Remote Control Ceiling Fan Light Wont Turn Off

To determine the cause of the fan speed malfunction follow the steps below.

Remote control ceiling fan light wont turn off. However the light on the fan works and the remote does control the light. Replace the ceiling fan capacitor. If you want to stop the fan but still use the light you have to use the pull cord or the remote. When i turn the power back on the fan goes back on.

Make sure the blue wire from the receiver is wired to the blue or black with white stripe if a hunter from the fan. Reset the fan remote. Turn on the power from the mains. Once complete return the battery and cover the remote.

I tried replacing the battery for the remote already and i tried turning off the power to the house. One of the wires from the ceiling should be capped off usually the red one. Open the battery cover of your remote control under the battery will be a set of dip switches match the dip switch code from your old remote to the new remote test to see if the lights can be turned off. Reset the remote of your fan.

You can use that to turn the fan on and off. Dipswitches are toggle switches on the back of the remote. The remote module has a set of small dip switches on the side of the module. Turn off the ceiling fan and allow the blades to come to a full stop.

The bad news is the fan canopy must be dropped to access the receiver. Turn off the ceiling fan using the remote. If your ceiling fan won t turn on or your speed settings are not working properly you may notice a sharp change in the airflow. Change the switch setting to match the settings of the hand held remote control.

If the lights are still stuck on at this point it is time to replace the receiver. If you want to reset the remote. This will sync the ceiling fan remote with the receiver. If the above does not resolve the issue continue to the following steps to check for over heating.

Resetting your remote setting is easy and it only takes a few easy steps. The fan is on and won t turn off. For 10 seconds hold down the off button. Generally you ll need to open the housing to find it.

Typically there is also a wall switch. I hope this helps. Turn of your fan using its dedicated remote control. The first step is to see if the remote was faulty.

Wait for 30 seconds before turning the fan on again. Typical ceiling fan remote control modules are located above the ceiling fan support bracket in the ceiling. But if you have a unit that has both a light and a fan the wall switch will usually turn off both of them. It is controlled by a remote control only no switch.

The process will change the frequency settings and allow the remote to work again. Hunter fan remote reset follows the same steps making the troubleshooting easy. You will also find a corresponding set of dipswitches on the fan. Run the ceiling fan for a few minutes.